How to Apply Duracoat

Duracoat is a high-performance firearm finish that provides excellent protection against corrosion and wear. It is easy to apply and can be used to refinish old guns or to customize new ones. Here are the steps to follow to apply Duracoat:

Materials you will need: - Duracoat kit - Sandpaper (220, 400, 600 grit) - Cleaning solvent (acetone or gun cleaner) - Spray gun or airbrush - Compressor (if using spray gun) - Respirator mask - Gloves

Steps: 1. Disassemble the gun: Before applying Duracoat, you must disassemble the firearm and remove all parts that you do not want to coat. This includes the bolt, trigger, and any other small components that may get in the way.

2. Clean the gun: Once you have disassembled the firearm, clean all the parts thoroughly using a cleaning solvent such as acetone or gun cleaner. This will remove any oil, grease, or debris that may interfere with the adhesion of the Duracoat.

3. Sand the gun: Use sandpaper to lightly sand the surface of the gun, starting with 220 grit and moving up to 600 grit. This will roughen up the surface and create a better bonding surface for the Duracoat.

4. Apply Duracoat: Once the gun is clean and sanded, you can apply the Duracoat using a spray gun or airbrush. Be sure to wear a respirator mask and gloves to protect yourself from the fumes. Apply the Duracoat in thin, even coats, building up the finish gradually. Allow each coat to dry for at least 30 minutes before applying the next.

5. Cure the Duracoat: Once you have applied the final coat of Duracoat, let it dry for 24 hours. Then, cure the Duracoat by baking the gun in an oven at 250 degrees Fahrenheit for 2 hours. This will harden the Duracoat and make it more durable.

6. Reassemble the gun: After the Duracoat has cured, you can reassemble the gun and enjoy your new finish!

Note: The specific instructions and drying/curing time may vary depending on the brand of Duracoat you are using. Be sure to read and follow the manufacturer's instructions carefully.