Editing Openai/6964e172-93a0-8013-9baf-b12d96b905a2 (section)

=== Assistant: Perfect — this is actually good news. ===
Perfect — this is actually good news. Nothing is broken.

Your system simply doesn’t have Flatpak installed yet, that’s why:

<syntaxhighlight>fish: Unknown command: flatpak

</syntaxhighlight>

You already did the hard part (removing native Discord + OpenAsar). Now let’s finish cleanly.

==== Run: ====

<syntaxhighlight lang="bash">sudo pacman -S flatpak

</syntaxhighlight>

When it finishes, log out and log back in
(not a full reboot — just log out)

This is important so Flatpak paths are registered.

==== After logging back in, run: ====

<syntaxhighlight lang="bash">flatpak remote-add --if-not-exists flathub https://flathub.org/repo/flathub.flatpakrepo

</syntaxhighlight>

==== <syntaxhighlight lang="bash">flatpak install flathub com.discordapp.Discord ====

</syntaxhighlight>

Press Y when asked.

==== <syntaxhighlight lang="bash">flatpak run com.discordapp.Discord ====

</syntaxhighlight>

Log in → start a stream.

👉 Choose “Window” first, not full screen.

==== Inside Discord: ====

<syntaxhighlight>Settings → Advanced → Hardware Acceleration → OFF

</syntaxhighlight>

Close Discord → reopen → test again.

==== - Flatpak Discord ships newer Electron ====
* Correct PipeWire + portal permissions
* No OpenAsar interference
* Plasma Wayland officially supported

This is the setup most Arch + KDE users end up on.

==== Run: ====

<syntaxhighlight lang="bash">flatpak override --user --filesystem=host com.discordapp.Discord

</syntaxhighlight>

Then reopen Discord and try again.

==== Reply with: ====
# Did Discord launch successfully?
# Does window streaming work?
# Does screen streaming work?

Once this is confirmed, I’ll give you:
* best Plasma Wayland streaming settings
* how to reduce stream lag
* optional OBS + Discord combo (if you want)

You’re almost done — this was the correct path 👍