Editing Openai/681ff321-b350-8005-836e-b02aaee287ee (section)

===== #### =====
* Clean and dry the seam thoroughly.
* Reseal it with 3M 5200 Fast Cure or Sikaflex 291 LOT (lot = long open time).
* You may need to mask the seam line for a cleaner application.

This works, but isn’t a permanent fix, because the underlying flex/load issue is still there.

====== - If you're comfortable removing some cosmetic gelcoat or rubber molding at the seam: 1. Grind out a 1/4" V-groove at the failed seam. 2. Fill with epoxy thickened with colloidal silica, topped with fiberglass tape or mat. 3. Seal and paint with matching gelcoat. ======

This reinforces the joint and prevents water intrusion, but it's a moderate DIY fiberglass job—likely within your skillset.

====== If this becomes a recurring issue and you plan to keep the boat long-term, consider: ======
* Adding mechanical fasteners through the pod flange into the transom to support the adhesive bond.
* Internal sealing: Filling part of the pod cavity with 2-part closed-cell foam to prevent water pooling.
* Drain or inspection port: Adding a small deck plate on top of each pod to inspect and drain as needed.